Mede8er MED450X2 User Manual download pdf (Page 5)

INSTALLING A HARD DRIVE

a) b)

Make sure that the DC power cable is unplugged. Place the

rear panel screws as indicated in figure 1. Lift the cover from the rear side and remove it. Plug the SATA

Data and Power cables into a compatible 2.5" HDD as shown in figure b. Turn the Hard Drive upside down

and carefully fit it into the Hard Drive bay. Make sure the cables are not exposed or sticking out of the

casing. Place the heat conductive pad on the top side of the Hard Drive. Two sizes are supplied so use the

thicker one for 9mm hard drives and the thinner one for 13mm hard drives. Replace the cover and tighten

the 3 x rear screws.

Mede8er on a flat surface and unscrew the 3x

Unscrew 3 screw and lift cover off

Page4

OUT

2.5" Hard Drive Bay

2.5" SATA Hard Drive

Heat Conductive pad

1 2 3 4 5 6 7 8 9 10 ... 39 40

No comments

Mede8er MED450X2 User Manual Page 5